All projects03 of 13 · Li-Fi
03AWARDED

Li-Fi Data Transmission System

  • Hardware
  • Languages

Data, sent as light

A drawing of on-off keying, slowed down until single bits can be seen. It is not a recording of the link, and the real timing is not shown.

  • Red, on the beam and in the upper trace: the laser is on, which is a 1. A gap is the laser off, a 0. The bits spell “Li-Fi”, eight to a character, on repeat.
  • Green, in the lower trace: what the solar panel and its amplifier hand on. Under it is one mark for each bit read: filled for a 1, hollow for a 0.
  1. Laser

    A laser transmitter on an Arduino Mega switches the beam on and off: on-off keying.

  2. Light pulse

    The data crosses the gap as pulses of laser light. The real link was 50 m long.

  3. Solar receiver

    A solar panel catches the pulses, and an LM358 amplifier brings the signal up.

  4. Decode

    Firmware on the receiving side turns the pulses back into what was sent: text, or an 8×8 grayscale image.

The problem and the idea

Won Best Contemporary Project among 1,000+ teams at Engineering Clinics I (Fall 2024/25). A wireless link that sends data as laser light pulses and recovers it with a solar-panel receiver.

What I built

  • Laser transmitter on an Arduino Mega using on-off keying
  • Solar-panel receiver with an LM358 amplifier
  • Sends text and an 8×8 grayscale image over a 50 m link
  • Firmware for transmission and reception, plus link testing and debugging

The result

  • 50 mLink range
  • 1,000+Teams in the contest it won

Send a word across

A demonstration in the browser. Your word really is turned into bits and put back together from them, but nothing here passes through the hardware, and this is not the firmware's own framing.

“hello” left as 40 bits and was decoded as “hello”.

Stack

  • Arduino Mega
  • Laser Module
  • Solar Panel
  • LM358
  • Embedded C